99 -- SULLAIR COMPRESSOR,LS10 ROTARY SCREW AIRTEK DRYER,AUTO DRAIN 200VOLT MOTOR

Notice Date

October 17, 2000

Contracting Office

Procurement Division, Naval Air Station Oceana, Supply Dept. Bldg 730, Virginia Beach, VA 23460-5120

ZIP Code

23460-5120

Solicitation Number

N60191-01-Q-0001

Response Due

November 1, 2000

Point of Contact

caroline wiles 757-433-2447

E-Mail Address

caroline wiles 757-433-2447 (wilesc@nasoceana.navy.mil)

Description

The Regional Supply Oceana in Virginia Beach, Va is issuing Solicitation #N60191-01-Q-0001 as a request for quote (RFQ)for Sullair Compressor,LS10-25H Rotary Screw, Airtek Dryer, Auto Drain, 200 Volt Motor to include the following.Item 0001-(1)each as follows: Air Compressor: 1)Sound attenuating inclosure,2)Air-Cooled oil cooler with thermal mixing valve and 15 degree F. approach air-cooled after cooler, moisture seperator and drain fin and tube type,3)Sullube 8,000 hour lubrication/coolant fluid,4)Two stage heavy duty intake filter,5)High efficient air/fluid seperation,6)Bearing fluid reservior,7)Sullair control system,8)All standard components mounted, piped and wired on a cast steel housing with motor and airend flanged for permanent alignment,9)Factory trained technician to do compressor start-up and operator training.Dryer: 1)3 Valve bypass,2)Pre-Coalescing mechanical seperator,3)Pre-Filter with housing,4)After filter with housing,5)Moisure indicator,6)Electronic drains,7)Structural steel base,8)Pressure indicator,9)Pressure relief valve,10)Factory trained technician to do dryer start-up and operator training,Sullair Compressor, LS10-25H Rotary screw,airtek dryer,auto drain 200 Volt motor to include the following. Item 0002-(1)each as follows: Air Compressor:1)Sound attenuating inclosure,2)Air-Cooled oil coller with thermal mixing valve and 15 Degree F. approach air-cooled after cooler, moisture seperator and drain fin and tube type, 3)Sullube 8,000 hour lubricant/coolant fluid,4)Two stage heavy duty intake filter,5)High efficient air/fluid seperation,6)Bearing fluid reservoir,7)Sullair control system, 8)All standard components mounted,piped and wired on a cast steel housing with motor and airend flanged for permanent alignment,9)Factory trained technician to do compressor start-up and operator trained, Dryer: 1)3 Valve bypass,2)Pre-coalescing mechanical seperator,3)Pre-Filter with housing,4)After filter with housing,5)Moisture indicator,6)Electronic drains,7)Structural steel base,8)Pressure indicator,9)Pressure relief valve,10)Factory trained technician to do dryer start-up and operator training

Record

Loren Data Corp. 20001019/99SOL001.HTM (W-291 SN5044Y1)