Commercial Acquisition Department, Bldg 11, Naval Undersea Warfare Center Division, Newport, Code 59, Simonpietri Dr., Newport, RI 02841-1708

70 -- SHARCPAC MODULE W/XILINX FPGA DIGITAL I/O INTERFACE SOL N66604-99-Q-5052 DUE 063099 POC Jeanne Whiteman at (401) 832-1927 WEB: NAVAL UNDERSEA WARFARE CENTER DIVISION, NEWPORT, http://www.npt.nuwc.navy.mil/contract/. E-MAIL: Jeanne Whiteman, whitemanjy@npt.nuwc.navy.mil. The Naval Undersea Warfare Center Division Newport has a requirement for (20) twenty SHARCPAC Modules w/Xilinx FPGA digital I/O Interface. These modules will be implemented to provide a digital interface to the Digital Signal Processor (DSP) Boards using the available onboard Field Programmable Gate Array (FPGA) chip as the Input/Output (I/O) port. The SHARCPAC modules will be mounted on a custom, Naval Undersea Warfare Center-developed carrier board and thus requires that all connections take place from the bottom of the module and be implemented on a single 4.5" x 3.1" card. The modules shall be configured with a minimum of one (1) Analog Device ADSP-21060 digital signal processor (DSP), operating at a minimum of 40 MHZ. The processor shall have a minimum of ten (10) independent DMA controllers, a 240 MByte/sec communication bandwidth and must meet a 120 MFLOPS CPU performance. The DSP chip must have at least a 4MB of internal memory. The modules shall provide a minimum of six (6) 40 MByte/sec link ports, two (2) 40 Mbit/sec serial prots, Flag and IRQ signals for interface via the SHARCPAC connectors. The modules must include a Xilinx 4020E (or higher density) FPGA with a minimum of one hundred (100) TTL or CMOS configurable I/O pins. Note: These pins must be connectorized on the bottom of the module so as to plug in directly onto the carrier board, or provide through-hole openings for user-selectable connectors. The module connector height shall be 0.225 inches. Recommended connector for SHARCPAC module (pin) is the Samtec surface mount connector TFM-145-02-S-D-LC. The maximum SHARCPAC module width (from the bottom of the module connector to maximum component height on top of the module) shall be 0.7 inches. The module must operate on 5V power and consume no more than 10 watts. The module must operate at an ambient temperature between 0 degrees centigrade and 50 degrees centigrade. The vendor must provide the following development software and emulation support: Software Library for module initialization from PROM, FLASH memory, or the host system. Delivery of the modules will be F.O.B. destination, Newport, RI. The Government intends to award a single contract on a Firm Fixed Price basis. All responsible sources may submit a quotation which shall be considered by the Government. The desired delivery date is 30 Aug 99, the required delivery date is 15 Sep 99. Award is expected on or about 2 Jul 99. This acquisition is 100% Set Aside for Small Business. Our department no longer issues solicitations or amendments in paper form. Instead, they may be accessed at our web site http://www.npt.nuwc.navy.mil/contract/. We also provide electronic access in our Bid Room. Posted 06/07/99 (W-SN339757). (0158)

Loren Data Corp. http://www.ld.com (SYN# 0377 19990609\70-0004.SOL)