BLM, BC-660, Bldg #50, Denver Federal Center, P.O. Box 25047, Denver, CO 80225-0047

R -- LEAD DUST CLEANUP OF BUILDINGS NO. 4, 5, 6 AND 7 AT THE FORMER BUREAU OF MINES (BOM) ROLLA RESEARCH CENTER, ROLLA, MISSOURI SOL 1422N660Q982007 DUE 071098 POC Kathleen Shriver (303) 236-9442 E-MAIL: click here to contact KShriver, via E Mail, KShriver@MC1155WP.SC.BLM.GOV. The Bureau of Land Management BLM) is overseeing the transfer of the U.S. Bureau of Mines Rolla Research Center facilities to the University of Missouri Rolla. A lead assessment, using wipe samples has been performed and is available from the BLM Industrial Hygienist. The services include the clean-up of lead dust in Buildings 4 and 5 by environmental clean-up professinals who are licensed by the State of Missouri as lead abatement supervisors and lead abatement workers, using appropriate methods. Clean-up, both hepa-vac and wet-wiping, is to include all exposed horizontal surfaces, including beams and outside ductwork. Initial cleaning shall be performed using a hepa-vac to remove any gross contamination, followed by a wet cleaning with a TSP (Tri-Sodium Phosphate) solution. This should remove the oily residue. A third cleaning, using Ledizolv should remove any further lead residue. Disposal of all clean-up waste is to be in accordance with all federal, state, and local hazardous waste regulations, whichever is more stringent. Clean floors of Buildings No. 6 and 7 using the methods outlined above, excluding storage area full of equipment. Leaves and debris on floors of these buildings are to be picked-up under this contract. All activities related to the clean-up of lead dust shall be performed in accordance with 29 CFR 1926.62, the OSHA Construction Standard for Lead, which includes personal protective equipment and monitoring. Sampling and analysis necessary to determine if the buildings meet the HUD/EPA clearance level. This will satisfy OSHA recommended criteria for lead dust using wipe samples. Building 4 contains approximately 2,900 square feet and housed a foundry operation. Building 5 contains approximately 2,400 square feet and housed the grinding room, a lab area, a restroom and a hoist system. Building 6 houses a storage area, a finished break/mail room, a finished office area, and a wet high intensity magnetic separator room. Building 7 contains finished offices and a laboratory area. The solicitation documents should be available on or about June 22, 1998. Written requests only. See Note 1 (0161)

Loren Data Corp. http://www.ld.com (SYN# 0070 19980612\R-0009.SOL)