Federal Aviation Administration, Acquisition Mgmt. Branch, Eastern Region, Fitzgerald Federal Bldg. 111, JFK Airport, Jamaica, NY 11430

54 -- PRE-FABRICATED FIBERGLASS SHELTERS SOL DTFA05-98-R-78036 DUE 030698 POC Nadene C. Fontano Contracting Officer (718) 553-3081 The Federal Aviation Administration, Eastern Region, has a requirement to purchase several fiberglass shelters to be used as equipment/work sites for Air Navigation Aids for various facilities. The intention is to award an Indefinite Quantity/Indefinite Delivery Type Contract for a base year expected to begin April 1, 1998 through September 30, 1998 with two (2) one year option periods. We are currently in the process of identifying contractors capable of providing fiberglass shelters that can be designed specific to FAA needs. As a minimum the shelters must satisfy the following requirements: Sizes: The FAA may require shelters that have an interior height of 8 feet in any or all of the below listed sizes. 8' x 6', 8' x 8', 8' x 10', 8' x 12', 8' x 14', 12' x 12'. Construction: The manufacturing process shall provide for an interior and exterior to include the roof that is of fiberglass. The wall cavity shall be insulated to minimum of R11. Structural support shall provide for the following minimum loads, wind 70psf, live roof 200psf. All material used in the fabrication of the interior and exterior to include the roof shall be of exterior commercial grade. The footing and floor shall be waterproof. The floor shall be insulated to a minimum of R11. The floor shall be constructed to have a live load (as specified). Minimum load ratings of 200psf. Maximum load ratings of 600psf. The floor shall be attached to skid beams of hot dipped galvanized steel channels. The skid beam shall have extension plates for lifting the entire shelter. Each shelter shall have a 36 inch wide x 84 inch high aluminum exterior door of welded construction. The door shall have stainless steel, ball bearing, tamper proof hinges with 3 point latch and deadbolt lock. The doorway shall have a fiberglass weather hood. The FAA must have flexibility to specify location of door. Power Distribution: One 100 AMP, 120/240 VAC, Single Phase 60 HZ multi space (as specified) main breaker, bolt in utility power panel in a NEMA 1 surface mount enclosure. One surge arrestor (as specified) multiple (as specified) duplex receptacles. One (as specified) exterior receptacle on a ground fault circuit interrupter. All interior wiring must be surface mounted in conduit meeting ANS/NFP-70 National Electric Codes latest revision. Lighting: As specified, surface mounted florescent light fixtures with RF1 noise suppression filters. One exterior door light with vandal resistant lens. HVAC: Each unit shall have a wall mounted air conditioner (location as specified) with a separate thermostat control and have a fiberglass weather hood. Heating shall be electric base board with separate thermostat control. The heating and air conditioning units shall provide sufficient temperature for the size building required to maintain a nominal constant interior temperature of 68 degrees. Accesories: Grounding. Shelters shall have a connection of a grounding electrode conductor to the shelters skid assembly. Shelters shall have a sixteen inch (16") grounding plate. The shelter shall have an intrusion alarm with form C contracts. Exterior building color shall be aviation orange and white over a seamless fiberglass coating. Companies who have the capability of providing the above described shelters, should fax over a letter of interest and capability to Nadene Fontano at (718) 995-5685 by March 6, 1998. A solicitation will then be issued and contractors proposals will be evaluated based upon: Past performance, equipment design -- conformance with statement of work, financial capability, time of delivery and price. (0054)

Loren Data Corp. http://www.ld.com (SYN# 0309 19980225\54-0002.SOL)