|
COMMERCE BUSINESS DAILY ISSUE OF SEPTEMBER 23,1997 PSA#1936Lockheed Idaho Technologies Company, P.O. Box 1625, Idaho Falls, ID
83415-3521 99 -- MAGNETIC GRADIOMETERS SOL CBD088 DUE 100697 POC Steve Lewis WEB:
Idaho National Engineering & Environmental Laboratory Procurement
Homepage, http://www.inel.gov/procurement/litco/index.html. E-MAIL:
Steve Lewis, sl4@inel.gov. Lockheed Martin Idaho Technologies Company.,
PO Box 1625, Idaho Falls, ID 83415-3521 MAGNETIC GRADIOMETERS. Lockheed
Martin Idaho Technologies Company (LMITCO) is requesting an expression
of interest for supplying low-cost high-performance magnetic
gradiometers to LMITCO. The total number to be purchased has not been
finalized but should be in excess of 100. The general specification
requirements for the magnetic gradiometers are: (1) The housing shall
be a maximum 14 in. long by 2 in. diameter aluminum tube. (2) Power
Input (3 pins) +12 VDC, -12 VDC, and ground. (3) Signal Output (2 pins)
bipolar ( ) 5 VDC and ground. (4) Magnetometer Range 100,000 nT. (5)
Gradiometer Range: 30,000 nT/m at full scale output (absolute gradient
dependent on sensor spacing). (6) Gradiometer Noise < 3 nT/m rms
between 0.1 -- 30 Hz and < 2 nT/m rms between 0.1 -- 3 Hz. (7)
Output Impedance 100 Ohm. (8) Accuracy < 0.1 % between 20,000 nT/m.
(9) Linearity < 0.05 % between 20,000 nT/m. (10) The sensor
gradient output shall not drift more than +/- 3 nT/m over a period of
2 minutes when held in a static gradient field. (11) A minimum 2 mm
aluminum housing with end closures shall be provided for RF shielding.
(12) A method to null approximately 95% of the static background
magnetic gradient field shall be provided. One acceptable method would
be to use a potentiometer adjustment. The supplier shall be
responsible for designing, and fabricating the gradiometer. Respondents
shall send their organizational capabilities and qualifications
(include publications and references for similar work) to: Mr. Steve
Lewis, PO Box 1625, 1955 Fremont Avenue, Idaho Falls, Idaho,
83415-3521. All interested suppliers must respond within 15 days after
publication. LMITCO will determine qualifying firms based on responses
to this announcement and solicit only those firms deemed responsive
based on the partial requirements listed above. (0261) Loren Data Corp. http://www.ld.com (SYN# 0244 19970923\99-0003.SOL)
99 - Miscellaneous Index Page
|
|