|
COMMERCE BUSINESS DAILY ISSUE OF AUGUST 23,1996 PSA#1665Department of Commerce, Mountain Administrative Support Center,
Procurement Division, MC3, 325 Broadway, Boulder, CO 80303-3328 52 -- GAS-OPERATED PISTON GAUGE SOL NB8380006780JW DUE 091896 POC
Jacqueline Wright (303) 497-5282 The National Institute of Standards
and Technology (NIST) intends to enter into a sole source contract with
DH Instruments, Inc. 1905 West Third Street, Tempe, Arizona under the
authority of 41 U.S.C. 253(c) (1)--Only one responsible source, to
provide a piston gage capable of operating as a primary pressure
standard over the entire pressure range of 5 kPa to 7 MPa. This system
is to be operated with either nitrogen or helium gas in both absolute
and gage modes with a total uncertainty in pressure of 0.002% for
pressures up to 350 kPa and 0.005% for pressures up to 7MPa. The system
is to be highly automated, including on-board electronics to measure
and correct for the effects of piston temperature, ambient temperature,
barometric pressure, and humidity; an integrated vacuum gage measuring
the vacuum under the bell jar is also required. The required pressure
range is to be measured with two integrated piston/cylinder sets of 35
mm diameter and 8 mm diameter; this requirement is to enable
interchangability with (and thus certification against) the pressure
standards maintained by the Pressure and Vacuum group of the NIST,
Gathersburg, Maryland. The starting mass load must be no greater than
500 grams and the starting pressure must be no greater than 5 kPa and
100 kPa for the two piston cylinders Kn - 10 kPa/kg ceramic
piston-tunsten carbide cylinder respectively. DH Instruments is the
only known manufacturer capable of meeting the agency's requirements.
No RFQ is available; however, interested sources may respond by
submitting documentation and literature that clearly demonstrates the
capability to meet this requirement. Responses must reference Synopsis
No. NB838000606780JW. In the absence of other qualified sources, it is
the intent to award a sole source contract with DH Instruments, Inc.,
Tempe, AZ. (0234) Loren Data Corp. http://www.ld.com (SYN# 0201 19960822\52-0001.SOL)
52 - Measuring Tools Index Page
|
|