Department of the Navy, NAWCAD, Contracts Competency Division, MS 32, 22541 Millstone Road, Patuxent River, MD 20670-5304

95 -- BED PLATES SOL N00421-96-R-5027 DUE 022196 POC Sandy Leighton, Contract Specialist, Code 2622SL, 301-342-3310 x19 Linda Suggs, Contracting Officer, Code 2622LS, 301-342-3310 X11. The Naval Air Warfare Center Aircraft Division (NAWCAD), Patuxent River, Maryland, has a requirement for a total of eighteen (18) bed plates (also referred to as base plates and surface plates). The material used for each bed plate shall be a chrome molybdenum, copper alloyed iron with a 35,000 to 45,000 psi tensile strength. Brinell hardness shall be between 180-200 for each plate. The top of each plate shall be machined to a 125 microfinish with a flatness of +/- .005 over any ten feet (10') square area. The side, end and bottom pads of each plate shall have a 250 microfinish. Each plate shall contain leveling system installers to be used in conjunction with anchor bolts for coaxial leveling and bed-plate hold-down. Flush mounted covers shall be supplied for each anchor bolt pocket. The points for leveling and anchoring of each plate shall be evenly spaced and symmetrically located approximately three feet (3') in any direction. An anchor bolt shall be supplied for each point location for each plate. For each plate the T-Slot throats shall be as-cast to 1.12'' running longitudinally on twelve inch (12'') centers starting six inches (6'') in from each edge. For each plate the T-Slot shall end in a gutter at one end and dead-end at the opposite end. The gutter shall not have a drain hole. Each T-Slot shall have a 1 1/2'' clamping configuration. The dimensions of the plates vary. Five (5) plates shall be 8' x 15' x 7''. Five (5) plates shall be 6' x 15' x 7''. Three (3) plates shall be 6' x 9' x 7''. Two (2) plates shall be 6' x 18' x 7''. One (1) plate shall be 9' x 10' x 7''. One (1) plate shall be 8' x 9' x 7''. One (1) plate shall be 8' x 12' x 7''. DELIVERY: On or about 01 JUL 96. DESTINATION: NAWCAD, Patuxent River, Maryland. The government will issue a Request for Proposal (RFP). All requests for copies of the RFP must be submitted in writing to the attention of Sandy Leighton, Code 2622SL, at the address stated above, or may be faxed to (301) 342-1161. RFP Issuance Date: On or about 19 JAN 96. All responsible sources may submit a proposal which shall be cnsidered by this agency. This requirement is 100% set-aside for small business concerns. Standard Industry Code (SIC): 3321. Small Business Size Standard: No more than 500 Employees. See Numbered Note(s): 1. (0356)

Loren Data Corp. http://www.ld.com (SYN# 0268 19951227\95-0001.SOL)