Arnold Engineering Development Center, ATTN: AEDC PKP, 100 Kindel Drive, Suite A332, Arnold AFB, TN 37389-1332

34 -- IRONWORKER TOOLS SOL F40650-96-B-0007 DUE 012296 POC Sue Tate, Contract Specialist, (615)454-7801, Tony Clayborne, Contracting Officer. Universal ironworker, equal to a Buffalo universal ironworker with the following features: punch station with single punch tool for structural sections or plate; 2 round punches and one each flat and bevel die bar cutter station with knives for angle (square and miter cuts) rounds and squares. Flat bar shear station with reversible shear blades. Built-in notcher at punch end, built-in coper at shear end, work support for flat bas shear station, Bijur manual central lubrication system, pneumatic anti-repeat foot controls. Fully enclosed combination gear and flywheel guard, slug chutes at punch and coper stations. 7 1/2 HP normal torque motor, 208-230/460-550 volt, 3 phase, 60 hz, 1800 rpm, nema, design ''B'' totally enclosed, fan cooled, horizontal ball bearing, magnetic combination full voltage starter in automotive nema type 12 enclosure, with 110 volt control circuit transformer and fused disconnect switch and heavy duty oil tight start-stop push-button and ground indicating pilot light in cover. Unit to also include one special block for 3'', 4'', and 5'' beams and channels; one set of round punches and matching dies, sizes 3/16'' to 1 7/16'', in 1/32'' increments (41 sizes); one set of round dies for use with special die block, sizes 7/32'' to 27/32'', in 1/32'' increments (21 sizes). Also include operations, service, maintenance manual and a parts breakdown book. (0339)

Loren Data Corp. http://www.ld.com (SYN# 0191 19951206\34-0001.SOL)