|
COMMERCE BUSINESS DAILY ISSUE OF NOVEMBER 24,1995 PSA#1476Directorate Of Contracting/Bldg 1233, Oo-Alc/ 6072 Fir Avenue, Hill Air
Force Base, Ut 84056-5820 53 -- SEAL SOL F42620-96-R-64146 DUE 010296 POC For copy, PKX-2/Pamala
Chaffee/(FAX)801-777-7522, For additional information contact Aircraft
Avionics/Lfke/(801)777-5966 Item 0001 NSN 5330-01-353-7224WF P/N:
5003864-01, Conductive transparency fairing seal for F-16, diam 50 ft-0
in long. Material: fluorosilicone rubber per MIL-R-25988, type II class
I. 69ea. Applicable to: F16. Destn: Hill Air Force Base, Ut 84056-5820.
Delivery: 28 Jun 96 69 ea Qualification requirements: Sources must be
qualified prior to being considered for award. The solicitation will
contain instructions for obtaining further information on this
requirement. The requirements of FAR 9.202(A) have been completed and
copies of the qualification requirements and standards may be obtained
as described in the solicitation. These qualification requirements
apply to line item(s) all The approximate issue/response date will be
11 Dec 95. The anticipated award date will be 20 Feb 96. Written
procedure will be used for this solicitation. To: Texstar Inc, Grand
Prairie Tx 75050-2552. No telephone requests. Only written or faxed
requests received directly from the requestor are acceptable. All
responsible sources solicited may submit a bid, proposal, or quotation
which shall be considered. Award will be made only if the offeror, the
product/service, or the manufacturer meets qualification requirements
at the time of award in accordance with FAR clause 52.209-1. The
solicitation identifies the office where additional information can be
obtained concerning qualification requirements is cited in each
individual solicitation. It is suggested that small business firms or
others interested in subcontracting opportunities in connection with
the described procurement make contact with the firm(s) listed.
Requests for copies of solicitations must reference the entire
solicitation number, including purchasing office identification number.
To expedite your request, limit the number of individual solicitation
numbers requested per letter to not more than 10. Don't request
information on this requirement until after the issue date. This part
required engineering source approval by the design control activity in
order to maintain the quality of the part. Existing unique design
capability, engineering skills, and manufaturing knowledge by the
qualified source(s) require acquisition of the part from the approved
source(s). The approved source(s) retain data rights, manufacturing
knowledge, or technical data that are not economically available to the
Government, and the data or knowledge is essential to maintaining the
quality of the part. An alternate source must qualify in accordance
with the design control activity's procedures, as approved by the
cognizant Government engineering activity. The qualification procedures
must be approved by the Government engineering activity having
jurisdiction over the part in the intended application. (0325) Loren Data Corp. http://www.ld.com (SYN# 0313 19951122\53-0001.SOL)
53 - Hardware and Abrasives Index Page
|
|