Tennessee Air National Guard, 240 Knapp Blvd., Attn. 118 LS/LGC, Nashville, Tennessee 37217-2538

66 -- INSTRUMENTS AND LABORATORY EQUIPMENT Sol DAHA40-95-R-8005. Contact Contracting Officer Lannie L. Summers (615)399-5630. Item one, NSN: 6625-01-378-8012, Test Set, Electronic Circuit Plug, Huntron Model RP388 or approved equal, Qty: One (1) each, Specifications: Power 110 volts 60 Hertz, Size: 23''W x 26''L, Enclosure feature: single item w/housing, test type: computer controlled electromechanical probe, permits storage of analog signatures of PCB's/automates PCB troubleshooting, phase: single, robotic prober, functional description: identifies test point locations, stores signatures of good components, and automatically compares PCB signature w/stored on hard drive, probe speed 5 in. per sec or 12.5cm per sec; accuracy porm 4 mils; min. resolution 2 mils; max. z travel 3 in. repeatability 2 mils over 12 in. of travel; board under test max. size 14 in. by 14 in.; test time for board with 5029-pin IC's under 10 minutes, mounts over the body of a Huntron 5100DS Semiconductor test set. Item two, NSN 6625-01-348-9634, Test Set, Semiconductor Device, Huntron Model 5100DS or approved equal, Qty: One (1) each, Specifications: Power: 32 watts max. 115VAC 60Hz, test frequency: 200Hz, display: 2.8'' diagonal CRT, test connectors: 64, 40 & 20 pin IDC connectors for DIP clip cables and a 40 PIN ZIF socket for individual component testing, a GPIB interface board: IEEE-488, 2 meters or more of GPIB cable, DIP clip cables; 8, 14, 16, 18, 20, 22, 24, 28, and 40 pin dip clips, front end adapter kit, ranges should have 4; ranges: high - Vs(Vpk) 60, Zs(Kohm) 74, Isc(mA rms) 0.6, Pmax(mW) 6, Pdiode(mW) .2; Medium 2: Vs(Vpk) 20, Zs(Kohm) 27, Isc(mA rms) 0.6, Pmax(mW) 2, Pdiode(mW) .2; Medium 1: Vs(Vpk) 15, Zs(Kohm) 1.2, Isc(mA rms) 8.5, Pmax(mW) 23, Pdiode(mW) 2; Low: Vs(Vpk) 10, Zs(Kohm) 54ohm, Isc(mA rms) 132, Pmax(mW) 232, Pdiode(mW) 33. It is believed that Huntron Instruments Inc., is the sole source with the required specifications. Company must provide in-house training and support. This procurement is a small business set-aside. All responsible small business concerns may submit a quotation based upon the above specification to the above address within thirty (30) days of publication of this notice. However, sources possessing experience and demonstrated capability to furnish the required item and service to accomplish the above without delay, are to supply pertinent information in sufficient detail to demonstrate the ability to provide the required items and services. (261)

Loren Data Corp. http://www.ld.com (SYN# 0306 19950922\66-0002.SOL)