82d Contracting Squadron/LGCC, 136 K Avenue Ste 1, Sheppard AFB TX 76311-2739 Attn:/Marcy Fragomeli

Z -- INSTALL LOAD FRAMES SOL F41612-95-B0059 DUE 091195 POC Marcy Fragomeli tel: 817/676-5181/Contracting Officer, Kenneth F McNeely, 817/676-5180. Work consists of the following: Install three suspended loading/ checkout frames to be furnished by the government to include 3 load frames, load frame installation kit, cruise missile pylon, SRAM launcher, AGMBRL adapters and loading frame modification kit. The frames shall be ceiling mounted from existing structure in accordance with TO's 11N-H5079-2, 11N-H5091-4 and H5079-2. The contractor shall install all accessories, leg assemblies, AFT hoist and rotator assembly. The contractor shall install the cruise missile pylon, SRAM launcher and AGMBRL adapters to the load frames. The contractor shall install the launcher loading frame modification kit to two of the frames. The work to install the load frames generally consists of the following: raise and clamp load frame to the structural beams; transfer holes to support structure and fittings; shim, level and align frames; install epoxy resin, plates, sleeves and bolts; and install leg assemblies, AFT hoist and rotator assembly. The contractor shall make all hydraulic connections to one load frame to provide a complete and usable piece of training equipment. The contractor shall provide hydraulic system tests, operational checkout tests, isolation checks, and load tests. The contractor shall furnish and install (Reference Section VII of TO 11N-H5079-2) fittings, fiberglass plates, shims, bolts, washers, bushings and nuts, epoxy resin and other consumables. The building structure has been specifically designed and constructed to carry the load frames to be installed. Structural support beams are W14x90 steel beams supported by building trusses (bottom flanges of W14x90 steel beams are +/-17'-0'' AFF). Load frames are approximately 27 feet x 7 feet x 2 feet in size and weigh approximately 16,000 pounds each. Contractor shall verify all existing dimensions AND WILL NOT PRESUME DIMENSIONS INDICATED IN THE TECHNICAL ORDERS ARE CORRECT. After installation of load frames, contractor shall paint all existing ferrous metal that is currently painted on the load frames and associated hardware with enamel paint conforming to Federal Spec TT-E-508/509 or approved equal. Estimated mailing date of solicitation: 10 Aug 95. Estimated cost of project is between $25,000 and $100,000. Performance period is 30 calendar days. Requests must be in writing. Telephone requests will not be honored. Acquisition is being issued for full and open competition. Availability of this solicitation is limited to one copy per requestor. Copies will be furnished on a first-come, first-serve basis until the supply is exhausted. (0201)

Loren Data Corp. http://www.ld.com (SYN# 0198 19950721\Z-0006.SOL)