SOLICITATION NOTICE
A -- MetalGateValve
- Notice Date
- 4/18/2025 3:44:20 PM
- Notice Type
- Solicitation
- NAICS
- 332911
— Industrial Valve Manufacturing
- Contracting Office
- SLAC Natl Accel Lab -DOE Contractor Menlo Park CA 94025 USA
- ZIP Code
- 94025
- Solicitation Number
- SLAC_355468_MetalGateValve
- Response Due
- 5/1/2025 5:00:00 PM
- Archive Date
- 05/16/2025
- Point of Contact
- Katherine Jill A. Coh, Phone: 6509262770
- E-Mail Address
-
kcoh@slac.stanford.edu
(kcoh@slac.stanford.edu)
- Description
- SLAC National Accelerator Laboratory is operated by Stanford University for the Department of Energy. As a management and operating contractor, subcontracts awarded by the Laboratory are not Federal procurements, and are not directly subject to the Federal Acquisition Regulations in 48 CFR. Nonetheless, certain Federal laws, Executive Orders, and regulations may affect our DOE approved purchasing system, as required by statute, regulation, or contract terms and conditions. Hi, The following Addendum is being issued for the subject Request for Quotation: SLAC_355468_MetalGateValve Question - Can you please confirm the quantity for this project? Answer � qty 1 This Addendum modifies the Request for Quotation and must be acknowledged. Failure to acknowledge all addenda could make your proposal non-responsive. Please confirm that the submitted proposal is not changed because of this addendum. If proposal sent is revised because of this, please submit the revised proposal. The following changes are hereby made to the appropriate documents contained the above-mentioned Request for Quotation (RFQ). All other terms and conditions of the RFQ remain the same. Thank you very much. Kind Regards, Jhamie Serena Procurement Commodities Team SLAC National Accelerator Laboratory 2575 Sand Hill Road Menlo Park, CA 94025 P- 650-926-2201 The following is attached for you to complete and review: 1.) Buy American Act (BAA) 2.) Equal Employment Opportunity (EEO) 3.) FP Commercial Supplies-Services T&C�s ( August 2023 Required item(s) are listed below: All metal gate valve Technical Specifications below: The Flange must be - DN 40 CF-F. Pneumatic double acting must be with solenoid valve and with position indicator. Body: A dimension must be customer specific 60 mm Plate: window round must be 12 mm; window material must be sapphire. Vendor must satisfy the pressure range from SLAC level 1 UHV criterion to 2 bar(abs). Differential pressure must be ? 2 bar on gate, ? 1 bar at opening. Conductance must satisfy 100 ls-1 The Bake-out temperature must be ? 300 �C for valve body, ? 200 �C for actuator (for max 100h), ? 80 �C for Position indicator, ? 80 �C Solenoid. Heating and cooling rate must be ? 50 �C h-1. Material must be following. � Valve body : 1.4435, AISI 316 L � Flange : 1.4435 ESU, AISI 316 L ESR � Gate : 1.4435, AISI 316 L � Mechanism : 1.4435, AISI 316 L � Bellows : 1.4435, AISI 316 L The seal must be followings. � Bonnet metal: silver plated � Gate metal: silver plated � Actuator: FKM (Viton�) Radiation resistance must be followings. � Valve body : 108 Gy (1010 rad) � Actuator : 105 Gy (107 rad) � Position indicator : 105 Gy (107 rad) � Solenoid : 104 Gy (106 rad) Volume of pneumatic actuator must be 0.27 l / 0.01 ft3. Compressed air min. � max. overpressure must be 4 - 8 bar / 58 - 116 psig. Compressed air connections must be G ?� (USA: ?"" NPT). Actuation time must be following. � Closing : ? 1.5 sec � Opening : ? 1.5 sec Behavior in case of compressed air pressure drop must be following. When the valve is closed, the valve must remain in closed position at the drop. Behavior in case of power failure must be following. When the valve is closed, Valve must remain in closed position. When the valve is open, Valve must be closed. Delivery on-site as soon as possible. Less than 20 weeks AROrequired. Quote is for product only; no on-site services permitted. Source selection will be based on Lowest Priced Technically Acceptable Method and best Lead-Time. Please provide a price and lead time quotation by 5/2/2025 Send quote to Jhamieb@SLAC.stanford.edu. Please be advised that the requirement was also posted in SAM.gov. Is there any room for additional discount such as for Academic, ICPT, GSA, or Government Institutions? Buy American Act Certification (BAA) applies to awards over $10,000. Representations & Certifications Rider is required. Once completed the Reps and Certs is valid for one year until renewal. If you have already completed one within the year please disregard. Otherwise, please complete and return. All subcontractors are required to register in the System for Award Management (www.sam.gov). If possible, please provide a link to your webpage for published price list to substantiate for the prices quoted. The resulting purchase order will be issued on a fixed price basis. SLAC National Accelerator Laboratory Terms and Conditions for Fixed Price Commercial Supplies and Services (Rev. August 2023) will be made a part of the resulting order. Please mark up terms and conditions if you wish to negotiate. No mark ups mean that you accept SLAC Terms and Conditions. Payment Terms will be NET-30 Freight terms will be FOB Destination Prepaid and Add You are requested to mark and identify proprietary/confidential information provided in response to the solicitation. Contact me directly with any questions. Kind Regards, Jhamie Serena Procurement Commodities Team SLAC National Accelerator Laboratory 2575 Sand Hill Road Menlo Park, CA 94025 P- 650-926-2201
- Web Link
-
SAM.gov Permalink
(https://sam.gov/opp/7851ecf1cfa1423588bcc0b03d4ee6af/view)
- Place of Performance
- Address: Menlo Park, CA 94025, USA
- Zip Code: 94025
- Country: USA
- Zip Code: 94025
- Record
- SN07414017-F 20250420/250418230043 (samdaily.us)
- Source
-
SAM.gov Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's SAM Daily Index Page |