SOLICITATION NOTICE
T -- AFTO 350 REPAIRABLE ITEM PROCESSING TAG
- Notice Date
- 9/17/2024 2:51:48 PM
- Notice Type
- Combined Synopsis/Solicitation
- NAICS
- 323111
— Commercial Printing (except Screen and Books)
- Contracting Office
- Customer Services Washington DC 20401 USA
- ZIP Code
- 20401
- Solicitation Number
- 547-819R1
- Response Due
- 9/20/2024 8:00:00 AM
- Archive Date
- 10/05/2024
- Point of Contact
- Deborah Buckey, Phone: 21476704514, Jermaine Berryman, Phone: 21476704512
- E-Mail Address
-
dbuckey@gpo.gov, jberryman@gpo.gov
(dbuckey@gpo.gov, jberryman@gpo.gov)
- Description
- PRODUCT: This specification is for proofing, printing, numbering, corner cutting, drilling, packing, and shipping of tags TITLE: AFTO 350 REPAIRABLE ITEM PROCESSING TAG QUALITY LEVEL: III Quality Assurance Through Attributes (GPO Publication 310.1, effective May 1979 (Rev. 09-19)) applies. QUANTITY: 3,000,002 TRIM SIZE:� 3-1/4 x 7-1/2""� � � � � � � � � � � DESCRIPTION:� PRINTING: Tag prints face and back in black ink, consisting of text and lines. Printed tags must provide clean, dense, and legible type matter. An approximate 5/16 x 15/16 screened area will print at the bottom of back side of tag; screened area is to remain open and not fill in. Print head-to-head. CONSTRUCTION: Drill/punch one round hole; 1/4"" in diameter, centered on the top 3-1/4"" Dimension, center of hole 3/16"" from top of tag. Reinforce both sides of tag with a hard fiber patch. No metal eyelet or stringing required. Corner Cut: Clip both corners with diagonal cuts at the top left and right (patch end). NUMBERING: Number each tag on the face side in two (2) places (same 6-digit number in each place), parallel to the 3-1/4"" way, in the TAG NO. areas. Number from 0000003 through and including 3000002 & use 0000001-0000002 For Samples only � (See Distribution) repeating the sequence until the entire quantity is accomplished. DO NOT INCLUDE ANY NUMBERS THAT END IN 000 (three zeroes). Numbers to be 3/16 -l/4"" high. The number at the bottom of the tag must be placed one-sixth (l/6"") from bottom edge of tag to ensure visibility in file utilized; the corresponding number should also be placed l/6"" up from the perforation. Numbering is to be in black ink. There are to be no missing numbers other than the ending 000 numbers. �PERFORATION: �Perforate each tag the full 3-1/4'' way) approximately 2"" from bottom. The perforation �is to align with the rule just above the text for item 16. SUPPLY DOCUMENT NUMBER on face side of �tag and just above the text for item 29 on the back side of tag.
- Web Link
-
SAM.gov Permalink
(https://sam.gov/opp/d4c50e6e0b894c1faa723677c3de7bd5/view)
- Record
- SN07214066-F 20240919/240917230113 (samdaily.us)
- Source
-
SAM.gov Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's SAM Daily Index Page |