SOLICITATION NOTICE
19 -- Handi Flat Work Barge
- Notice Date
- 8/26/2024 10:31:42 AM
- Notice Type
- Solicitation
- NAICS
- 336612
— Boat Building
- Contracting Office
- W07V ENDIST ST PAUL SAINT PAUL MN 55101-1323 USA
- ZIP Code
- 55101-1323
- Solicitation Number
- W912ES24Q0119
- Response Due
- 9/6/2024 12:00:00 PM
- Archive Date
- 09/21/2024
- Point of Contact
- Ben Knutson, Phone: 6512905418, Jesse Onkka, Phone: 6512905444
- E-Mail Address
-
benjamin.t.knutson@usace.army.mil, Jesse.L.Onkka@usace.army.mil
(benjamin.t.knutson@usace.army.mil, Jesse.L.Onkka@usace.army.mil)
- Small Business Set-Aside
- SBA Total Small Business Set-Aside (FAR 19.5)
- Description
- 1.� GENERAL DESCRIPTION The Operations Section of the US Army Corps of Engineers, St Paul District is solicitating a Handi-Flat Work Barge for use on the Mississippi River Locks and Dams. �Quantity is for one (1) unit, with an option for one (1) or two (2) additional units that will be awarded at the same time if we decide to exercise.� The unit cost must include delivery and unloading at the Fountain City Service Base in Fountain City, WI. 2. SPECIFICATIONS: A.� ��� Beam 12� wide. B. ���� Length 40� long. C. ���� Overall hull molded depth of 4�. D.����� Rakes on both ends of the barge. E.� ��� Rake chines shall not be a welded seam. F.����� All structural steel construction made from standard Grade A-36 or higher. NO ALUMINUM. G.���� Hull thickness no less than �� thick. H.����� Head log thickness including the radiused corners on the bow and stern not less than 3/8� thick. I.������ Minimum of three (3) bulkhead sections allowing four (4) watertight compartments. K.����� Minimum of two (2) flush mounted 18� diameter deck hatches per compartment mounted in opposite corners.� ABS Certified waterproof Hatch covers. L.������ Minimum allowable deck loading of 750 lbs./sq ft (PSF). M.��� All barge surfaces shall be sand-blasted free for rust and mill scale. O.���� All paint shall be two-part epoxy rated for marine application.� P.����� Exterior coating shall be primed and painted of the hull, sides and deck. Q.���� Barge hull and side coating shall be standard black coating at least 8 mils thick. R.����� Barge deck shall be standard red non-slip coating. S.����� Barge interior compartment coating shall be standard white coating. T.����� Shall come complete with six (6) industry standard 24� kevels with three (3) centered on each side. U.���� Each of the two long sides and front should have rubber rub rails that can be replaced and that fit in a steel track.� Minimum of 6� high and 3� wide extending along the full length. V.����� Barge must have stake pockets (w/ drain) for removable handrailing that is included. W.��� Removable handrailing must have a vertical height of between 39� to 45� and support a load of at least 200 lbs. applied within 2� of the top edge. X.����� Must include a steering counsel complete with steering wheel, steering control and shift/throttle cables to the transom. Y.����� Includes recessed cable tray area between counsel and transom for control cables and gas lines. Z.����� Includes portable davit arm with the following specifications: Certified by the manufacturer. 2,000 lb. lift capacity. 12-volt electric winch. Up to 10� tall. Up to 7� hook reach. Three permanent bases (stern, starboard, bow). AA.���� Must include two (2) fully rigged 75 hp four-stroke motors with long shafts, low torque lower units, complete with stainless steel propellors sized for the application. Not counter rotating. AB.���� Rigging to include standard gauges such as tachometer, water pressure, fuel, battery power. AC.���� Must include two five-gallon portable gas tanks, and three (3) 12-volt AGM maintenance-free batteries with selector switch between all three batteries. AD.���� Includes supplied wiring and connections between the battery selector switch to the motors and three davit arm locations. Includes one (1) on-board three-bank battery charger located in the consol. �� AE.���� Laser or water-jet cut steel USACE logo and US ARMY CORPS OF ENGINEERS approved font painted and welded to each side, centered above the waterline.� Minimum 6� tall font painted white and logo painted red. AF.���� Serial number 009 laser or water jet cut and welded to rear side above waterline.� Minimum 6� tall font painted white. If we exercise the optional barges they shall be numbered 010 and 011 respectively. AG.��� Digital or hardcopy versions of the shop/concept drawings shall be submitted prior to fabrication for approval. AH.���� As-built drawings shall also be sent to the government as .dwg file and hard D-size drawings.
- Web Link
-
SAM.gov Permalink
(https://sam.gov/opp/142886f766f743e58bbff4c2d4defeae/view)
- Place of Performance
- Address: Fountain City, WI 54629, USA
- Zip Code: 54629
- Country: USA
- Zip Code: 54629
- Record
- SN07185959-F 20240828/240826230121 (samdaily.us)
- Source
-
SAM.gov Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's SAM Daily Index Page |