SOLICITATION NOTICE
45 -- Eyewash and Safety Showers
- Notice Date
- 9/12/2020 7:31:47 PM
- Notice Type
- Combined Synopsis/Solicitation
- NAICS
- 238220
— Plumbing, Heating, and Air-Conditioning Contractors
- Contracting Office
- USDA ARS PA AAO ACQ/PER PROP FORT COLLINS CO 80526 USA
- ZIP Code
- 80526
- Solicitation Number
- 12805B20Q0217
- Response Due
- 9/18/2020 2:00:00 PM
- Archive Date
- 10/03/2020
- Point of Contact
- James Porter, Phone: 9792609491
- E-Mail Address
-
james.porter@ars.usda.gov
(james.porter@ars.usda.gov)
- Small Business Set-Aside
- SBA Total Small Business Set-Aside (FAR 19.5)
- Description
- This is a combined synopsis/solicitation for commercial items prepared in accordance with the�format in FAR Subpart 12.6, as supplemented with additional information included in this notice.�This announcement constitutes the only solicitation; quotes are being requested and no other�written solicitation will be issued. Solicitation 12805B20Q0217�is issued as a request for quotes. �This solicitation document and�incorporated provisions and clauses are those in effect at this current time. This is a small business set aside under NAICS code 238220. �Only small business can participate in this solicitation. �Verification of business�size will be completed via the vendor's SAM registration. The USDA ARS Plains Area Plant and Animal Genetic Resources Preservation�in Fort Collins, CO �is requesting quotes for�the following: Installation of Tempering Valves at the National Laboratory for Genetic Resources Preservation (NLGRP), 1111 South Mason St, Fort Collins CO 80521 Overview- This project is to provide all labor and materials needed to install water temperature tempering valves for the eyewashes and safety showers at NLGRP, 1111 South Mason St, Fort Collins CO 80521-4500. Work shall meet ANSI Z358.1-2004 standards. Currently the laboratory has approximately 22 eyewash and safety showers located throughout the building that lack a tempered water supply. Scope of Work: Provide and install tempering valves for eyewashes and safety showers locations shown below. Tempered Water is defined by ANSI as �A flushing fluid temperature conducive to promoting a minimum 15 minute irrigation period. A suitable range is 16-38�C (60-100�F).� The majority of the existing eyewashes are installed immediately adjacent to sinks and have a hot water supply within a 1 foot. Where possible, installation of tee fittings to supply sink and eyewash is approved. Safety showers are located in hallways and are close to accessible hot water piping. Where it is necessary to add on a �tee� or other fitting to existing copper water supply lines (examples of which would be hallway showers, room 151, room 229), the work shall be done using copper pipe with shut off valve to allow for isolation of the line for service or emergencies. Minimum flow rates shall be: Eye Wash stations 0.4 gpm at 30psi ����������������������������������������������������������� Eye/Face Wash station 3gpm at 30 psi � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � �Drench Showers- 20 gpm at 30psi Room #�������������������� Description�� Hot water distance Note 130- Hallway��� Shower����������������������������� 3� 130- Lab����������� Eyewash����������� �������������� 1� 132- Lab������������ Eyewash����������� �������������� 1� 133- Hallway��� Shower����������������������������� 3� 133- Lab������������ Eyewash����������� �������������� 1� 134- Lab������������ Eyewash����������� �������������� 1� 135- Hallway��� Shower����������������������������� 3� 135- Lab������������ Eyewash����������� �������������� 1� 137- Lab������������ Eyewash����������� �������������� 1� 151- Receiving Combination������������������ �������������� 20��������� Closest hot water in hall to the west 159- Lab������������ Eyewash����������� �������������� 1����������� A single tempering valve can supply 159- Hallway��� Shower�������������� ����������������������������� both of room 159 fixtures 222- Lab bay��� Eyewash����������� �������������� 1� 226- Hallway-W����������� Shower�������������� 3� 226- Hallway-E������������� Shower�������������� 3� 229- Lab����������� Eyewash����������� �������������� 10��������� Eyewash mounted in center island. HW above 231- Lab������������ Eyewash����������� �������������� 1� 232- Lab����������� Eyewash�������������������������� 1� 233- Lab����������� Eyewash�������������������������� 1� 243- Lab- S�� Eyewash������������������� 1� 243- Lab-N��� Eyewash������������������� 1� 244- Lab������� Eyewash������������������� 1� 254- Hall������ Shower���������������������������������� ?? Work to be done during regular laboratory hours which are 7:00am and 4:30pm. Materials- tempering valves shall be HAWS AXION� Thermostatic Mixing Valves 9201 EW or equivalent.� Provision 52.212-1, Instructions to Offerors-Commercial, applies to this acquisition. Provision 52.212.2 Applies. �The government will award a contract resulting form this solicitation�to the responsible offeror whose offer conforming to the solicitation will be most advantageous to�the Government, price and other factors considered. �The following factors shall be used to�evaluate offers: 1. Price 2. Technical Capability 3. Past Performance � Clause 52.212-4, Contract Terms and Conditions-Commercial Items, applies to this acquisition. Clause 52.212-5, Contract Terms and Conditions Required To Implement Statutes ore Executive Orders-Commercial Items, applies to this acquisition. All requests for information regarding this solicitation must be submitted in writing via email to� James Porter�at james.porter@usda.gov no later than 1600 CDT on 9/18/2020. Quotes are due to James Porter�via email at james.porter@usda.gov. �Offers are due by 09/18/2020�by 1600 CDT. �Offerors must have a active registration�in the System for Award Management at SAM.gov at the time�of solicitation closing to be considered for this award. �Offerors must return the following to be�considered for this award: 1. �Standard Form 18 - Request for Quote (Attached to Solicitation): �Must fill out blocks 11e�(unit price), 11f (amount), 12a-f, 14, 15, and 16a-c. 2. A description of the project on company letterhead. Primary Point of Contact.: James Porter, Contract Specialist james.porter@usda.gov Place of Contract Performance: Plains Area Plant and Animal Genetic Resource Preservation, Fort Collins, CO 80521 United States
- Web Link
-
SAM.gov Permalink
(https://beta.sam.gov/opp/da82f44fae0c4642bbb5da23fa7d909a/view)
- Place of Performance
- Address: Fort Collins, CO 80521, USA
- Zip Code: 80521
- Country: USA
- Zip Code: 80521
- Record
- SN05795528-F 20200914/200912230132 (samdaily.us)
- Source
-
SAM.gov Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's SAM Daily Index Page |