SOLICITATION NOTICE
39 -- Custom Built Hydraulic Lift Cart
- Notice Date
- 5/26/2020 1:14:34 PM
- Notice Type
- Combined Synopsis/Solicitation
- NAICS
- 333923
— Overhead Traveling Crane, Hoist, and Monorail System Manufacturing
- Contracting Office
- FA8126 AFSC PZIMB TINKER AFB OK 73145-3305 USA
- ZIP Code
- 73145-3305
- Solicitation Number
- FA8126-20-Q-0044
- Response Due
- 6/5/2020 12:00:00 PM
- Archive Date
- 06/20/2020
- Point of Contact
- Jaqueline Hughes, Anthony Dollard, Phone: 4057394810
- E-Mail Address
-
jaqueline.hughes@us.af.mil, anthony.dollard@us.af.mil
(jaqueline.hughes@us.af.mil, anthony.dollard@us.af.mil)
- Small Business Set-Aside
- SBA Total Small Business Set-Aside (FAR 19.5)
- Description
- Custom Built Hydraulic Lift Cart that meets specifications as outlined in attached item description.� 100% Small Business Set-aside. Amendment: The following question was asked, ""For the hydraulic�cart front forks; what is the pocket opening height�where the forks must go between�the floor and the bottom of the equipment to be lifted? We want this information so we know how thin to make the front legs that hold the 3"" caster wheels. If the cart if not intended to 'fit' under any specific device with a limited underside clearance (from the floor to the bottom of equipment) then the total height of the front supports holding the wheels will not matter. If the height�from floor to equipment underside is (for example) 3"" exact then it will change the way we would propose to build the front leg supports versus a clearance (for example) of 4"" of clearance."" Answer, ""We believe the majority of things we want to use this lift for falls in the 4� - 4.5� range from ground to underside of the equipment.""
- Web Link
-
SAM.gov Permalink
(https://beta.sam.gov/opp/886ca4779b3b40108fcadcc2c625692b/view)
- Record
- SN05670399-F 20200528/200526230148 (samdaily.us)
- Source
-
SAM.gov Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's SAM Daily Index Page |