SOLICITATION NOTICE
49 -- Unload Unit Checking Fixture NSN 4920-00-003-0769
- Notice Date
- 4/21/2020 9:10:02 AM
- Notice Type
- Presolicitation
- NAICS
- 332994
— Small Arms, Ordnance, and Ordnance Accessories Manufacturing
- Contracting Office
- FA8554 AFLCMC EBKA AFSC ROBINS AFB GA 31098-1670 USA
- ZIP Code
- 31098-1670
- Solicitation Number
- FA8554-20-UNLDCHCKFIXTURE_F15C_D
- Response Due
- 5/6/2020 2:00:00 PM
- Archive Date
- 05/21/2020
- Point of Contact
- Shasta Rieker, Contract Specialist, Phone: 478-926-9264, Fredrick Sterdivant, Contracting Officer, Phone: 478-222-3363
- E-Mail Address
-
shasta.rieker@us.af.mil, fredrick.sterdivant@us.af.mil
(shasta.rieker@us.af.mil, fredrick.sterdivant@us.af.mil)
- Description
- The�unload unit checking fixture (P/N 117D2174) NSN 4920-00-003-0769 is designed to test the F15C/D main gun. The unload unit checking fixture is used to mount to the gun unload unit and checks for proper unit-gun timing during installation procedures. The US Air Force owns the complete Technical Data Package (TDP) for this item; therefore it is looking to have this item manufactured by any number of qualified contractors. The projected buy quantity is�22 units over 4 years. Service requirements for this item may be performed by the contractor during option years/ordering periods,�or by the Air Force itself depending on the different needs. The The Air Force owns the complete Technical Data package for the unload unit checking fixture.� The technical data package is fully sufficient to manufacture the unload unit checking fixture.� There are a few items in the TDP such as the case, latches and a few others that are commercial items and are no longer available.� However the vendor manufacturing this item will have an easy time finding a suitable replacement� as these are common hardware types that will need to be accepted by engineering at Robins AFB.� All of the other data is sufficient to manufacture. The unload unit checking fixture is a go/no go gage for the F15C and D main gun alignment.� The�unload unit checking fixture�must meet the technical requirements laid out in the drawing package.� The�unload unit checking fixture�must be able to give accurate go/no go reading for the alignment.� These requirements can easily be met in the commercial fabrication market.� Machine shops have the ability to meet some very tight tolerances as long as they are required by Technical Data Package.� Additionally, a First Article Test is required to be performed by the Contractor. Please contact our office for the Technical Data Package.
- Web Link
-
SAM.gov Permalink
(https://beta.sam.gov/opp/d1a8c8348a1d4deba39b58ed9140c10d/view)
- Record
- SN05631052-F 20200423/200422060405 (samdaily.us)
- Source
-
SAM.gov Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's SAM Daily Index Page |