SOURCES SOUGHT
99 -- Well Closure and Sealing
- Notice Date
- 3/13/2020 5:51:49 AM
- Notice Type
- Sources Sought
- NAICS
- 237110
— Water and Sewer Line and Related Structures Construction
- Contracting Office
- W4MM USA JOINT MUNITIONS CMD ROCK ISLAND IL 61299-5000 USA
- ZIP Code
- 61299-5000
- Solicitation Number
- W52P1J-20-R-5004
- Response Due
- 4/3/2020 1:00:00 PM
- Archive Date
- 08/03/2020
- Point of Contact
- Megan K. Frost, Phone: 3097821471, Molly J Lewis, Phone: 3097821837
- E-Mail Address
-
megan.k.frost2.civ@mail.mil, molly.j.lewis4.civ@mail.mil
(megan.k.frost2.civ@mail.mil, molly.j.lewis4.civ@mail.mil)
- Description
- 13 March 2020- � Sources Sought for Well Closure and Sealing � W52P1J-20-R-5004 � The Army Contracting Command - Rock Island is issuing this sources sought notice for Well Closure and Sealing at Rock Island Arsenal (RIA), located in Rock Island, Illinois. This requirement is projected to use NAICS code 237110. RIA is projecting a design/build project to remove approximately 1300 linear-ft of aggregate and then seal in its entirety (approximately 1600 linear-ft) of the disused water well. Projected details are as follows. CONSTRUCTION REQUIREMENTS Abandon water well 51 per Illinois Administrative Code Title 77 Chapter I Subchapter r Part 920 section 920.120 subsections (b)(7). Conduct the required permitting, license application, and coordination with the IL-EPA and County Public Health prior to sealing the water well per IAC Title 77 Chapter I Subchapter r Part 920 Section 920.120 Subsection (e)(1). Contractor is required to construct or employ the necessary instruments and equipment to accomplish the task of sealing the deep water well. Provide the information, documentation, and water well abandonment forms and reports required by the IL-EPA and Rock Island County Public Health as part of the well sealing documentation per IAC Title 77 Chapter I Subchapter r Part 920 Section 920.120 Subsections (e)(2). Completed site shall be seeded and sloped to allow water to drain away from BLDG050 and BLDG071 without ponding. CLEARING DEEP WELL 051 Remove fill aggregate and debris from well 51. Dispose of aggregate and debris. Stock pile and allow material to decant if required per proper dispose requirements. Collect samples as necessary to classify and dispose of the removed material and water. DEMOLITION Remove Building (BLDG051). Remove materials and equipment. Remove, full-depth, foundation materials; or the top 24inches (measured per finished grade) and break the bottom of the foundation so that it drains. Remove below grade utilities and utility conduits to and from BLDG051 that are no longer in use�at least 50 linear foot each instance. Remove 50ft of well discharge pipe. Remove 50ft of unused utilities and conduits (electrical, communication, etc.) Utilities discovered and not removed during the utility demo shall be noted on the red line drawings. WELL CONDITION SURVEY Perform a downhole video inspection including both sideview and downview survey and measurements once the well is fully evacuated. Report findings in a condition log and provide video on DVD media (Microsoft Windows Video Player). Document and photograph (still images) findings of each casing, shoe, exposed grout, any crevices, and at a minimum ever 100ft of well depth. Use findings to finalize design and prepare the 100% and �For Construction� design set. WELL WATER CONDITION TESTING This water well is near an active RCRA site with contaminated groundwater. The most recent groundwater sampling of this water well detected VOCs and metals, but were below the set remediation objectives. Obtain three sets of representative water samples from the water well. Occasions for water sampling: The first set of samples is to be collected prior to construction work beginning, The second set is to be collected the same day the downview camera survey is completed, and The third set is be obtained the day the water well sealing operation commences. The representative sample sets shall be laboratory tested on each occasion for: VOCs using EPA Method 8260B, Total metals (chromium, iron, and manganese) using EPA Method 6010B, and Dissolved metals (chromium, iron, and manganese) using EPA Method 6010B. The information listed above is for information purposes only, and may be revised at time of solicitation release.� This is a SOURCES SOUGHT NOTICE only and shall not be construed as a solicitation or as an obligation on the part of the Government. This notice does not obligate the Government to award a contract or otherwise pay for the information provided in the response. The Government will not accept requests for meetings or briefings. No phone solicitations or email with regards to the status of the Request for Proposal (RFP) will be accepted prior to the solicitation release. Interested parties should reply with their information no later than 3:00pm Central Standard Time on 03 April 2020. Information should include previous within scope project details, dates, and organizations that work was provided to, your business cage code, small business designation, and your business size status. The point of contact at the Army Contracting Command - Rock Island is Megan Frost, megan.k.frost2.civ@mail.mil
- Web Link
-
SAM.gov Permalink
(https://beta.sam.gov/opp/95029ee6e0f74027b25b3b411092123e/view)
- Place of Performance
- Address: Rock Island, IL 61299, USA
- Zip Code: 61299
- Country: USA
- Zip Code: 61299
- Record
- SN05588949-F 20200315/200313230145 (samdaily.us)
- Source
-
SAM.gov Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's SAM Daily Index Page |