SOLICITATION NOTICE
N -- Install Three (3) Automatic Door Openers
- Notice Date
- 8/28/2019
- Notice Type
- Synopsis
- NAICS
- 238290
— Other Building Equipment Contractors
- Contracting Office
- Department of Veterans Affairs;Network Contracting Office 2;James J. Peters VA Medical Center;130 West Kingsbridge Road;Bronx NY 10468-3904
- ZIP Code
- 10468-3904
- Solicitation Number
- 36C24219R0186
- Response Due
- 9/4/2019
- Archive Date
- 12/3/2019
- Point of Contact
- Richard.Adu@va.gov
- Small Business Set-Aside
- Service-Disabled Veteran-Owned Small Business
- Description
- This notice is for Solicitation Number 36C24219R0186 for Install Three (3) Automatic Door Openers at James J. Peters VA Medical Center, 130 West Kingsbridge Road, Bronx, NY. 10468-3904. This shall be a Service Disabled Veteran Owned Small Business (SDVOSB)Set-Aside. As a result, all SDVOSBs may submit a proposal which will be considered by the agency. This requirement is classified under NAICS Code 238290 and has a size standard of $15.0 Million. The cost estimate range for this requirement less than $25,000. Scope of Work: The Contractor shall provide all necessary labor, tools, professional certifications, and materials to supply and install three (3) automatic door openers in Rooms 7B-01, 7B-01 Bathroom, and 2E Day Surgery. Door openers shall be complete in all manner specified, and shall be installed per manufacturers assembly, installation, testing, and documentation requirements and all applicable codes and specifications. Specifications for door assemblies are as follows: Room 7B-01 Bathroom Door ASSA ABLOY SW200i Swing Door Operator Equipment: Surface Applied Handing: Single LH Inswing Inswing Reveal: 0" - 1/2" Reveal Cover: 39.25" Position Switch: 3 Pos.Toggle Switch, CL Sensors Platform: ANSI 156.19 Finish: Clear Anodized - Class 1 Arm Finish: Clear Configuration: Standard Additional Hardware (per door) Equipment: Push Plates Square PTO: Push Plate Square 4.75" Engraved "Push to Open" Quantity: 1 Square Surface Box: Surface Box Square 4.75" Quantity: 1 Wireless Receiver: 9 Volt 433 frequency Quantity: 1 Wave Plate: - Wave Plate: - Jamb Mount: - Wave Plate: - Wave Plate: - Decal Kits: Low Energy Decal Kit Quantity: 1 Key Chain Transmitter with one Button Receiver 390 MHz Frequency - Digital Installation during normal working unless otherwise indicated. Electric Strike Other DA245 [1] Single SW200i Automatic operator Clear anodized finish [1] Electric strike [1] Push plate for interior side of room [4] Push button remotes to open the door from either side. Buttons for keychain. ASSA ABLOY SW200i Swing Door Operator 1 Equipment: Surface Applied Handing: Single LH Inswing Inswing Reveal: 0" - 1/2" Reveal Cover: 39.25" Position Switch: 3 Pos.Toggle Switch, CL Sensors Platform: ANSI 156.19 Finish: Clear Anodized - Class 1 Arm Finish: Clear Configuration: Standard Additional Hardware (per door) Equipment: Push Plates Square PTO: Push Plate Square 4.75" Engraved "Push to Open" Quantity: 1 Square Surface Box: Surface Box Square 4.75" Quantity: 1 Wireless Receiver: 9 Volt 433 frequency Quantity: 1 Wave Plate: - Wave Plate: - Jamb Mount: - Wave Plate: - Wave Plate: - Decal Kits: Low Energy Decal Kit Quantity: 1 1 Key Chain Transmitter with one Button 4 Receiver 390 MHz Frequency - Digital 1 Installation during normal working unless otherwise indicated. Electric Strike Other DA 245 1 Electric Strike Excludes: 110 volt electrical service to operator header Prepared Opening to accept package(s) Glass and Glazing Perimeter Caulking Adjacent Storefront Transom Framing above door Gang Box, 1 pair 18 gauge low voltage wiring, and any necessary conduit or wire mold for each push plate Header support for surface mounted swing door operator(s) Removal and disposal of existing doors Painting, patching and repairing of floors, walls and ceilings Signed and Stamped shop drawings by a Certified Professional Engineer Room 7B-01 DOOR ASSA ABLOY SW200i Swing Door Operator Equipment: Surface Applied Handing: Single RH Inswing Inswing Reveal: 0" - 1/2" Reveal Cover: 51" Position Switch: 3 Pos.Toggle Switch,CL Sensors Platform: ANSI 156.19 Finish: Clear Anodized - Class 1 Arm Finish: Clear Configuration : Standard Additional Hardware (per door) Equipment: Push Plates Jamb Mount Surface Box: Surface Box Jamb Mounting Quantity: 2 Square PTO: Push Plate Square 4.75" Engraved "Push to Open" Quantity: 2 Wave Plate: - Wave Plate: - Jamb Mount: - Wave Plate: - Wave Plate: - Decal Kits: Low Energy Decal Kit Quantity: 2 BEA, BR3X Relay Board Installation during normal working unless otherwise indicated. DK 26 Keypad and Electric Strike Other DA 245 Electric strike to be installed into frame. DK 26 Code entry to be installed on exterior/hallway side [1] Single Rh Inswing Clear anodized SW200i Surface mounted operator. DK 26 code entry Electric strike [2] Push plates [1] Push plate to be mounted at desk. Low voltage wiring needed to be ran for function switch and push plate to desk ASSA ABLOY SW200i Swing Door Operator 1 Equipment: Surface Applied Handing: Single RH Inswing Inswing Reveal: 0" - 1/2" Reveal Cover: 51" Position Switch: 3 Pos.Toggle Switch,CL Sensors Platform: ANSI 156.19 Finish: Clear Anodized - Class 1 Arm Finish: Clear Configuration: Standard Additional Hardware (per door) Equipment: Push Plates Jamb Mount Surface Box: Surface Box Jamb Mounting Quantity: 2 Square PTO: Push Plate Square 4.75" Engraved "Push to Open" Quantity: 2 Wave Plate: - Wave Plate: - Jamb Mount: - Wave Plate: - Wave Plate: - Decal Kits: Low Energy Decal Kit Quantity: 2 1 BEA, BR3X Relay Board 1 Installation during normal working unless otherwise indicated. 1 DK 26 Keypad and Electric Strike Other DA 245 1 Electric strike to be installed into frame. DK 26 Code entry to be installed on exterior/hallway side. Excludes: 110 volt electrical service to operator header Prepared Opening to accept package(s) Glass and Glazing Perimeter Caulking Adjacent Storefront Transom Framing above door Gang Box, 1 pair 18 gauge low voltage wiring, and any necessary conduit or wire mold for each push plate Header support for surface mounted swing door operator(s) Removal and disposal of existing doors Painting, patching and repairing of floors, walls and ceilings Signed and Stamped shop drawings by a Certified Professional Engineer Applicable taxes Operating Room Day Surgery Room Door Aluminum Door Operator ASSA ABLOY SW200i Swing Door Operator Equipment: Surface Applied Handing: Single RH Outswing Outswing Reveal: 0" 3 3/4" Cover: 39.25" Position Switch: 3 Pos.Toggle Switch, CL Sensors Platform: ANSI 156.19 Door Mtd. Presence Sensor: (2) DMPS SP32 M OP 43" Finish: Clear Anodized - Class 1 Arm Finish: Clear Configuration: Standard Additional Hardware (per door) Equipment: Push Plates 4.75" Square Push Plate: Engraved "Push to Open" with "HC Logo" Quantity: 2 Square Surface Box: Surface Box Square 4.75" Quantity: 2 Wave Plate: - Wave Plate: - Jamb Mount: - Wave Plate: - Wave Plate: - Decal Kits: Low Energy Decal Kit Quantity: 2 Installation during normal working unless otherwise indicated [1] Single SW200i Low energy automatic operator Clear anodized finish [2] push plates with plastic back boxes [2] door mounted safety sensors Removal of manual door closer ASSA ABLOY SW200i Swing Door Operator 1 Equipment: Surface Applied Handing: Single RH Outswing Outswing Reveal: 0" 3 3/4" Cover: 39.25" Position Switch: 3 Pos.Toggle Switch, CL Sensors Platform: ANSI 156.19 Door Mtd. Presence Sensor: (2) DMPS SP32 M OP 43" Finish: Clear Anodized - Class 1 Arm Finish: Clear Configuration: Standard Additional Hardware (per door) Equipment: Push Plates 4.75" Square Push Plate: Engraved "Push to Open" with "HC Logo" Quantity: 2 Square Surface Box: Surface Box Square 4.75" Quantity: 2 Wave Plate: - Wave Plate: - Jamb Mount: - Wave Plate: - Wave Plate: - Decal Kits: Low Energy Decal Kit Quantity: 2 Installation during normal working unless otherwise indicated. Excludes: 110 volt electrical service to operator header Prepared Opening to accept package(s) Glass and Glazing Perimeter Caulking Adjacent Storefront Transom Framing above door Gang Box, 1 pair 18 gauge low voltage wiring, and any necessary conduit or wire mold for each push plate Header support for surface mounted swing door operator(s) Removal and disposal of existing doors Painting, patching and repairing of floors, walls and ceilings Signed and Stamped shop drawings by a Certified Professional Engineer Special Work Requirements The Contractor will communicate with the Contracting Officer s Representative (COR) to schedule the repair visit during regular business hours of 8AM EST through 5PM EST, Monday Friday (excluding holidays). No special security clearance is necessary for this requirement and the Contractor will not be in proximity of any patient Protected Health Information. The contractor will need to acquire an identification badge for each worker and ensure the badge is worn in a visible location on the worker at all times while on the premises of the VA property. It is the responsibility of the contractor to park in the appropriate designated parking areas. Information on parking is available from the VA Police. The VA will not invalidate or reimburse for parking violations of the contractor under any conditions. Smoking is prohibited inside any buildings at the VA. Possession of weapons is prohibited. Enclosed containers, including tool kits, shall be subject to search. Violations of VA regulations may result in a citation answerable in the United States District Court. Project Completion: 90 Calendar Days from Notice to Proceed (NTP) All other details and information shall be contained in the solicitation which shall be posted on www.fbo.gov. The solicitation will be released on or about September 30, 2019. The response submittal address, date and time will be included in the solicitation. All prospective bidders must be currently registered in www.sam.gov, www.dnb.com (Duns and Bradstreet) and be registered and verified as a Service Disabled Veteran Owned Small Business (SDVOSB) in www.vip.vetbiz.gov at the time of offer submission and before award of this procurement. End of Description. NOTE: THIS NOTICE WAS NOT POSTED TO FEDBIZOPPS ON THE DATE INDICATED IN THE NOTICE ITSELF (28-AUG-2019); HOWEVER, IT DID APPEAR IN THE FEDBIZOPPS FTP FEED ON THIS DATE. PLEASE CONTACT 877-472-3779 or fbo.support@gsa.gov REGARDING THIS ISSUE.
- Web Link
-
Link To Document
(https://www.fbo.gov/spg/VA/BroVANAP/VAMD/36C24219R0186/listing.html)
- Place of Performance
- Address: Department of Veterans Affairs;James J Peters VA Medical Center;130 West Kingsbridge Road;Bronx NY
- Zip Code: 10468-3904
- Country: USA
- Zip Code: 10468-3904
- Record
- SN05421357-F 20190830/190828230011 (fbodaily.com)
- Source
-
FedBizOpps Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's FBO Daily Index Page |