MODIFICATION
51 -- Wire Repair Tool Sets
- Notice Date
- 8/20/2019
- Notice Type
- Modification
- NAICS
- 332216
— Saw Blade and Handtool Manufacturing
- Contracting Office
- Contracts Department Hwy. 547 Attn:B562-3C Lakehurst NJ 08733-5083
- ZIP Code
- 08733-5083
- Solicitation Number
- N68335-19-R-0190
- Response Due
- 8/23/2019
- Point of Contact
- Scott Bestreski, Contract Specialist, Phone 7323232901
- E-Mail Address
-
scott.bestreski@navy.mil
- Small Business Set-Aside
- Total Small Business
- Description
- Purpose of this amendment is to post all questions received along with the answers and to extend this solicitation. Q) 600-157-KC Wrench Set includes a case and wrench sizes 600-157-08 thru -24. The provided case will not meet the SOW 2.4 case requirements. Individual part numbers 600-157-08 thru -24 are also included on the tool list. which creates a duplication, these tools will be incorporated within a case that meets the SOW. If duplication was not intended, should part number 600-157-KC be removed? A) Proceed with eliminating duplicates and the extra non-spec case Q) TN-2478 is an alternate to AC4319. Both part numbers are listed under NSN 5120-01-468-5288. Source of supply for AC4319 is unknown. We request approval to provide part number TN-2478. A) The manufacturer for the parts are TIMES microwave systems. Per my records and communication with company engineers, AC4319 should actually cross with TN2964, while TN2478 should cross with AC4034. Both parts are capable of performing the exact same task, however we selected TN2964 (AC4319D) as it was easier on the maintainer to use. Only part number TN2964 (AC4319D) should be used. Q) Paragraph 7 notes: The case shall have a pressure equalizing valve. This valve shall not protrude beyond the enclosure. Can you further define the "enclosure"? A) This also applies to the reinforced corners, recessed handles, etc. The Skydyne case listed above and equivalent have corners sufficient to meet fleet needs Q) Paragraph 2.4 (5) third line notes "Handles shall be recessed" Statement per Skydyne: The size of each of these containers make a recessed handle very difficult. A handles inside a recessed dish will not fit around the frame in the front of the container, and while it will fit on the top of the cover, a handle in this location will make the container unwieldy. The non-recessed handle can be placed below the frame on the base shell. However, this will make the bail of the handle protrude below the bottom of the container. Therefore we would recommend riveting the spring loaded handle onto the edge frame. NOTE: THIS NOTICE WAS NOT POSTED TO FEDBIZOPPS ON THE DATE INDICATED IN THE NOTICE ITSELF (20-AUG-2019); HOWEVER, IT DID APPEAR IN THE FEDBIZOPPS FTP FEED ON THIS DATE. PLEASE CONTACT 877-472-3779 or fbo.support@gsa.gov REGARDING THIS ISSUE.
- Web Link
-
Link To Document
(https://www.fbo.gov/spg/DON/NAVAIR/N68335/N68335-19-R-0190/listing.html)
- Place of Performance
- Address: JBMDL Lakehurst, NJ
- Zip Code: 08733
- Country: US
- Zip Code: 08733
- Record
- SN05412073-F 20190822/190820230103 (fbodaily.com)
- Source
-
FedBizOpps Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's FBO Daily Index Page |