Loren Data's SAM Daily™

FBO DAILY - FEDBIZOPPS ISSUE OF MAY 01, 2014 FBO #4541
MODIFICATION

66 -- Radial Collimator - radialcollimator-1

Notice Date

4/29/2014
 

Notice Type

Modification/Amendment
 

NAICS

332710 — Machine Shops
 

Contracting Office

Department of Commerce, National Institute of Standards and Technology (NIST), Acquisition Management Division, 100 Bureau Drive, Building 301, Room B130, Gaithersburg, Maryland, 20899-1410, United States
 

ZIP Code

20899-1410
 

Solicitation Number

SB1341-14-RQ-0198
 

Archive Date

6/30/2014
 

Point of Contact

Joni L Laster, Phone: 301-975-8397, Don Graham, Phone: 3019758567
 

E-Mail Address

joni.laster@nist.gov, Donald.Graham@NIST.gov
(joni.laster@nist.gov, Donald.Graham@NIST.gov)
 

Small Business Set-Aside

N/A
 

Description

revised drawing per Amendment I AMENDMENT I The above referenced solicitation is hereby amended to respond to vendor questions and to provide an updated specification drawing as follows: Question: Number 5 on the notes of the drawing, foil frame spacers, can these be cast aluminum? Answer: Number 5 states "or equivalent", however, some may not interpret that to apply to the non-magnetic properties. Yes, cast aluminum is acceptable as it is equivalently non-magnetic. The note has been updated. Question: Could aluminum be used instead of stainless steel for the side plates? Answer: Number 4 needs to stay as non-magnetic stainless steel, 316 or equivalent as it is part of our shielding. Question: Can the size of the M16 hardware be reduced and the threaded nuts below the surface of the side plates? Answer: The M16 hardware is a max size as stated on the drawing. It can be smaller but not larger. Same goes for the overall assembly width with the max bolt size and sticking out; it is a max dimension, so if the contractor wants to have them flush with the sides to more easily meet the hard dimension on the casing width that is acceptable. A revised drawing, attached, entitled radialcollimator-1 is provided based on this amendment. The due date and time remains unchanged and all quotations must be received by May 5, 2014 at 3pm EST.
 

Web Link

FBO.gov Permalink
(https://www.fbo.gov/spg/DOC/NIST/AcAsD/SB1341-14-RQ-0198/listing.html)
 

Place of Performance

Address: 100 Bureau Drive, Gaithersburg, Maryland, 20899, United States

Zip Code: 20899
 

Record

SN03351696-W 20140501/140429234851-cf94b0b33f2e505872a4a8e52aaac39e (fbodaily.com)
 

Source

FedBizOpps Link to This Notice
(may not be valid after Archive Date)

---

| FSG Index  |  This Issue's Index  |  Today's FBO Daily Index Page |