MODIFICATION
38 -- Drilling mud Cleaning/Recycling System
- Notice Date
- 11/27/2009
- Notice Type
- Modification/Amendment
- Contracting Office
- U S GEOLOGICAL SURVEY, APS BRANCH OF ACQUISITION AND GRANTS3020 STATE UNIVERSITY DR. EAST, MODOC HALL STE 2002 SACRAMENTO CA 95819
- ZIP Code
- 95819
- Solicitation Number
- 10WRQQ0044
- Response Due
- 12/21/2009
- Archive Date
- 11/27/2010
- Point of Contact
- JOYCE STEVENSON CONTRACT SPECIALIST 9162789344 ;
- E-Mail Address
-
Point of Contact above, or if none listed, contact the IDEAS EC HELP DESK for assistance
(EC_helpdesk@NBC.GOV)
- Small Business Set-Aside
- N/A
- Description
- The purpose of this is to announce a change to the Specification for Drilling Mud Cleaning/Recycling System advertised 11/20/2009. Closing Date remains the same. Point of contact is jstevenson@usgs.gov (916) 278-9344. The specs are changed to the following:SPECIFICATIONS FOR DRILLING MUD CLEANING/RECYCLING SYSTEM"MULITFUNCTIONAL LINEAR MOTION SHAKER:"Dual deck or 2 units to handle 2 simultaneous flows. One deck (mud cleaner) handles desilter cones and the other deck works as a primary scalper. Each deck shall have 3 screens with approximately 28ft^2 surface area for each unit. Complete shaker will have a total surface area of 56ft^2."Minimum of 2 Linear vibrator motors will be 460volt, 3phase @ 60 Hz and have sealed pre-lubricated bearings. Unit will generate 5 G's minimum."Screens will use a wedge mounting system for easy installation and removal and be the angle shall be adjustable while in operation from +5 to -2 degrees. "SCALPER:"Primary scalper handles a flow of 500gpm. Screen area will be approximately 28ft^2."There will be access to the flow just out of the possum belly for sample retrival. "If dual deck, there shall be easy access to both top and bottom screens for fast replacement."DESILTER:"Handles 500gpm using approximately 28ft^2 of screen area and 6 @ 5" or 8@4" cones supplied by a 25 hp centrifugal pump. Cones are mounted above mud cleaner deck. Includes pressure gauge and isolating valves for each cone."MUD HOPPER:"High shear, low pressure style. 4" plumbing with 1" venture nozzle connected to centrifugal pump."MUD GUNS:"4 low pressure guns with 3" plumbing and " nozzles for agitation of mud. "CENTRIFUGAL PUMPS:"3 mechanically sealed pumps @ 3"x4"x13" driven by 460v, 3 phase, 60 Hz electric motors. Motor HP are as follows: 25Hp for cones, 20Hp for the mud hopper/mud guns (share same pump), and a 20hp for the charge pump. "PICKUP/TRASH PUMP:"10hp pickup pump for discharge pit. Will be remotely controlled and direct mud/cuttings to scalper."Will have a lifting hook for hoisting and moving unit."GENERATOR/ELECTRICAL:"Minimum 100 KW enclosed genset. Or meet full load amps (FLA) requirements for all electrical components. (Attach FLA calculations with quote to procurement officer). Engine shall be or meet tier 3 emission standards."Control Panel shall have manual circuit breaker, internal breakers for control circuitry, outside lighting, and 110v 1 phase 15amp for auxiliary outlet. "Motor Controllers for shaker motors, desilter pump, charge pump, hopper/mud gun pump, remote start/stop, and pickup/trash pump."Charge pump and pickup pump shall both have an extension cable with start/stop for remote operation. "Lighting of unit shall include complete lighting of upper deck (shakers, control panel, hopper, and walkways) and lower deck over pumps and genset area. "TANK AND SKID:"2500 to 3000 gallon, 2 compartment (clean/dirty) tank. "Tank shall have walkways above with railing surrounding the unit. Walkways will be a minimum of 2' wide and are predominantly fixed (minimal setup time is the objective). "Tank shall have a drain on each compartment at the lowest point (with access) for draining. "Tank shall have two (2) 4" suction ports on clean side to supply external pumps."All plumbing will be installed and connected so unit is turn key. "Tank will be sandblasted then power coated and baked to cure paint. "Ladder with hand rails for safe access to upper deck. Handle on front uprights of unit for use with steps on trailer."TRAILER:"Heavy duty, 3 dual wheel axle, air brakes, pintle hitch with DOT lighting. Steps on both sides for safe access up to trailer deck with handle on skid upright."Trailer and mud system total height, width, and weight will be highway legal."Trailer will not EXCEED 30' in total length."PAINTING:"All steel surfaces shall be professionally primed and painted a color approved by the USGS. "DRAWINGS, SPECIFICATIONS: "Drawings or photos of proposed unit, footprint of unit and trailer, and specifications and calculations for and of pumps, motors, generator, and trailer will be included with response to the procurement officer. 11/27/2009
- Web Link
-
FBO.gov Permalink
(https://www.fbo.gov/spg/DOI/USGS/USGS/10WRQQ0044/listing.html)
- Record
- SN02012500-W 20091129/091127233550-8f527cf5527954960ae0baae7c244dc3 (fbodaily.com)
- Source
-
FedBizOpps Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's FBO Daily Index Page |