Loren Data's SAM Daily™

fbodaily.com
Home Today's SAM Search Archives Numbered Notes CBD Archives Subscribe
FBO DAILY ISSUE OF JUNE 23, 2006 FBO #1670
MODIFICATION

58 -- Revise the Small Business Sources Sought for the MPM amplifiers

Notice Date
6/21/2006
 
Notice Type
Modification
 
Contracting Office
N68936 Naval Air Warfare Center Weapons Division Dept. 3 575 I Ave, Suite 1 Point Mugu, CA
 
ZIP Code
00000
 
Solicitation Number
N6893606R0100
 
Response Due
6/30/2006
 
Archive Date
7/30/2006
 
Point of Contact
Tim Byrnes, (805) 989-0959, timothy.byrnes@navy.mil
 
E-Mail Address
Email your questions to Timothy Brynes
(timothy.brynes@navy.mil)
 
Description
The purpose of this modification is to correct errors in the technical description as follows. Delete: The Type I MPM is an air cooled RF Amplifier capable of Continuous Wave (CW) operation. The Type I MPM?s operating frequency range is 2.0 Gigahertz to 6.0 Gigahertz. The MPM shall have a CW output power of 50 Watts minimum from 2.0 to 6.0 GHz and 100 Watts minimum form 2.9 to 3.5 GHz. The MPM shall have a small signal gain of 55 to 65 decibels (dB), and a maximum gain variation of =/- 3dB for any 1 GHz span. All residual noise components within =/- 100KHz shall be suppressed no less than 40 dB from the carrier. The MPM shall operate with a steady state power voltage of 27 plus or minus 4 VDC. The current drain shall not exceed 15 amperes current. The total weight of the MPM shall not be greater than 12 pounds. Replace with: The Type I MPM is an air cooled RF Amplifier capable of Continuous Wave (CW) operation. The Type I MPM?s operating frequency range is 2.0 Gigahertz to 6.0 Gigahertz. The MPM shall have a CW output power of 50 Watts minimum from 2.0 to 6.0 GHz and 100 Watts minimum form 2.9 to 3.5 GHz. The MPM shall have a small signal gain of 55 to 65 decibels (dB), and a maximum gain variation of +/- 3dB for any 1 GHz span. All residual noise components within +/- 100KHz shall be suppressed no less than 40 dB from the carrier. The MPM shall operate with a steady state power voltage of 27 plus or minus 4 VDC. The current drain shall not exceed 15 amperes current. The total weight of the MPM shall not be greater than 12 pounds. NAICS Code = 334220 Place of Performance = N/A Set Aside = N/A
 
Record
SN01074890-W 20060623/060621221252 (fbodaily.com)
 
Source
FedBizOpps Link to This Notice
(may not be valid after Archive Date)

FSG Index  |  This Issue's Index  |  Today's FBO Daily Index Page |
ECGrid: EDI VAN Interconnect ECGridOS: EDI Web Services Interconnect API Government Data Publications CBDDisk Subscribers
 Privacy Policy  Jenny in Wanderland!  © 1994-2024, Loren Data Corp.