SOLICITATION NOTICE
66 -- Combination & Miscellaneous Instruments
- Notice Date
- 7/12/2004
- Notice Type
- Solicitation Notice
- Contracting Office
- N00178 17320 Dahlgren Road Dahlgren, VA
- ZIP Code
- 00000
- Solicitation Number
- N0017804Q3043
- Response Due
- 7/19/2004
- Archive Date
- 10/1/2004
- Point of Contact
- XDS13-13 (540) 653-7765 XDS13-13 (540) 653-7765
- Description
- "This synopsis is being posted to both the Federal Business Opportunities(FBO) page located at http://www.eps.gov and the Navy Electronic Commerce on Line(NECO) site located at http://www.neco.navy.mil. While it is understood that FBO is the single point of entry for posting of synopsis and solicitations to the internet, NECO is the alternative in case FBO is unavailable. Please feel free to use either site to access information posted by the Navy Sea Systems Command." This is a combined synopsis/solicitation for commercial items prepared in accordance with the format in FAR Subpart 12.6, as supplemented with additional information included in this notice. FAR Subpart 13.5 procedures will be used. This announcement constitutes the only solicitation; proposals are being requested and a written solicitation will not be issued. The Naval Surface Warfare Center, Dahlgren Divis ion (NSWCDD) intends to purchase the following Aeroflex Brand Name or Equal COTS items: (1) Model 701Ti-110, IFF Transponder/Interrogator Test Set, and (2) Model SIM-701-01-110, Monopulse Antenna Simulator Base Unit. The specifications are as follows: IFF Transponder or Interrogator Test Set An IFF Transponder or Interrogator Test Set is an organizational level or 1st Line, portable battery operated test set for testing IFF transponders and interrogators installed in airborne, naval or land based platforms. This transponder must allow the operator to verify and certify the operation of MK10A, MK12, MK12 or Mode S IFF transponders with minimal intervention and allow testing to be conducted over the air or by direct connection. The following specifications must be met: TRANSPONDER MODE SPECIFICATION SIGNAL GENERATOR Output Frequency 1030 MHz (plus or minus 0. 01 MHz) RF Output Level (P1) Antenna Connector minus 3.6 to minus 53.6 dBm in 0.5 dB steps plus or minus 2.5 dB (minus 3.6 to minus 42.6 dBm) plus or minus 3.5 dB (minus 43.1 to minus 53.6 dBm) Direct I or O: minus 50.85 to minus 100.85 dBm in 0.5 dB Steps plus or minus 1.0 dB (minus 50.85 to minus 89.85 dBm) plus 2.0 dB (minus 90.35 to minus 100.85 dBm) Antenna VSWR: less than 1.5:1plus Gain 10 dB typical Range 6 ft to 250 feet Test Signals (Interrogations) PRF Rate Modes 1, 2, 3/A, 4, C: 235 Hz (plus or minus 5Hz) Mode S: 47 Hz (plus or minus 3 Hz) Operating Modes: 1, 2, 3A, 4, C, S, Intermode Pulse Rise and Fall Time Rise Time (all modes): 30 to 100 ns Fall Time (all modes): 30 to 200 ns Phase Modulation Transition Time: less than 80 ns Phase Balance:180 degrees (plus or minus 10 degrees) UUT MEASUREMENTS (REPLIES) XMTR Frequency Range 1087 to 1093 MHz Accuracy plus or minus 50 kHz Resolution 10 kHz XMTR Power Range 46 to 60 dBm Accuracy plus or minus 2 dB Resolution plus or minus 0.1 dB Effective Radiated Power (ERP) Range 48.5 to 57 dBm Accuracy plus or minus 2 dB Resolution 0.1 dB Receiver Sensitivity Range minus 67 to minus 79 dBm Accuracy plus or minus 2 dB Radiated Field Strength Range minus 69 to minus 77 dBm ENVIRONMENTAL AND POWER SPECIFICATIONS Power and Fuse Battery Operation Duration less than 1.5 hours Automatic Shutoff After 15 minutes of non use AC Power Requirements Voltage and Frequency 100 to 120 VAC, 60 Hz 220 to 240 VAC, 50 Hz Maximum Power Consumption 47 W Mains Supply Fluctuations: less than 10 percent of nomin al voltage Transient Overvoltage Installation Category II FUSE REQUIREMENTS F1 and F2 100 to 120 VAC 1.0 A, 250 V, Type F 220 to 240 VAC 0.5 A, 250 V, Type F ACCESSORY POWER AND FUSE SPECIFICATIONS Universal Crypto Umbilical Power Requirements AC Voltage and Frequency 100 to 120 VAC, 60 Hz, less than 2 A DC Voltage 22 to 29 Vdcm less than 2 A Universal Crypto Umbilical Fuse Requirements F1 (22 to 29 Vdc) 2 A, 250 V, Type F F2 and F3 (100 to 120 VAC) 2 A, 250 V, Type F KIV6 Crypto Interface Adaptor F1 1 A, 32 V, Type F ENVIRONMENTAL Operating Temperature minus 20 C to plus 50 C Humidity less than 80 percent up to 31 C, decreasing linearly to 50 percent at 40 C Use Pollution Degree 2 Altitude less than 13,124ft (4000 m) DIMENSIONS Approximately 28.4 cm Width; 36.1 cm Depth; 27.9 cm Height exclud ing spacer Approximately 11.2 in. Width; 14.2 in Depth; 11 in. Height excluding spacer WEIGHT maximum 34 lbs maximum 42 lbs with spacer section Monopulse Antenna Simulator This simulator simulates interrogator monopulse antenna characteristics to provide target simulation. This simulator must work in combination with a Transponder or Interrogator Test Set. The following specifications must be met: ELECTRICAL CHARACTERISTICS RF Transmit Path Loss (0 dB Attenuation) 28 dB (plus or minus 2 dB) Difference Antennas Output Relative to Sum Antennas (0 dB Attenuation) plus or minus 1.0 dB TRANSMIT ATTENUATION Range 0 to 31 dB Step Size 1.0 dB ACCURACY 0 to 15 db plus 0.4 dB (plus or minus 3 percent) 16 to 31 dB plus 0.5 dB (plus or minus 3 percent) Difference Antennas Phase Relative to Sum Antennas (0 dB Attenuation, both Channels) Selec tion plus or minus 90 degrees Accuracy plus or minus 20 degrees Phase Error due to Attenuation less than or equal to 45 degrees Phase Shift Between plus or minus 90 and minus 90 Selection 180 degrees (plus or minus 10 degrees) VSWR (Sum and Difference Ports) less than 1.25:1 Receive Path Loss 62 dB (plus or minus 2 dB) Frequency 1030 MHz (plus or minus 5.0 MHz) RF INPUT (SUM PLUS DIFF ANTENNAS) Peak Power plus 46.5 to plus 67 dBm max (45 W to 5 kW max) Average Power 30 W max SIGNAL AND CONTROL Remote Interface Comm2 and Comm3 RS232C (TXD, RXD, CTS DTR and GND supported) AIRCRAFT AZIMUTH INTERFACES BLANKING INPUT High Level (logic 1) input, differential plus 2.0 to plus 7.0 V Low Level (logic 0) input, differential plus 2.0 to minus 7.0 V Common Mode input voltage plus or minus 2.5 V max BLANKING OUTPUT High Level (logic 1) output differential plus 3.0 to plus 5.0 V Low Level (logic 0) output, differential plus 3.0 to minus 5.0 V Common Mode output voltage plus or minus 1.5 V max ACP/ARP Inputs 5 V TTL ACP/ARP Outputs 5 V TTL SYNCHRO INPUTS (S1, S2 AND S3) Level 11.8 Vrms, LL (plus or minus 10 percent) Frequency 400 Hz (plus or minus 10 percent) Input Impedance 30 k ohm min SYNCHRO REFERENCE INPUTS Level 26 Vrms, (plus or minus 10 percent) Frequency 400 Hz (plus or minus 10 percent) Input Impedance 5 k ohm min Bus Monitor MILSTD1553B POWER AND FUSE SPECIFICATIONS BATTERY OPERATION Duration greater than 6 hours AC POWER REQUIREMENTS Voltage and Frequency 100 to 120 VAC, 60 Hz 220 to 240 VAC, 50 Hz Maximum Power Consumption 75 W Mains Supply Fluctuations less than or equal to 10 percent of the nominal voltage Transient Over-voltage Instal lation Category II plus 28 Vdc (plus or minus 4.0 Vdc) Voltage plus 28.0 Vdc (plus 4.0 Vdc) Current 1.25 A maximum 2.0 A maximum Fault Current plus 5 Vdc OUTPUT Voltage plus 5.0 Vdc (plus 0.2 Vdc) Current 750 mA FUSE REQUIREMENTS F1 and F2, 100 to 120 VAC 1.5 A, 250 V, Type T F1 and F2, 220 to 240 VAC 0.75 A, 250 V, Type T ENVIRONMENTAL/MECHANICAL Weight 16.8 kg (37 lbs) maximum Dimensions (with LID) Approximately 29.2 cm high x 35.6 cm long x 38.1 wide Approximately 11.5 in. high x 14 in. long x 15 in. wide Operating Temperature 0 C to plus 50 C Storage Temperature Range minus 40 C to plus 70 C Relative Humidity less than or equal to 80 degrees up to 31C decreasing linearly to 50 percent at 40C Use Pollution Degree 2 Altitude less than or equal to 4000 m (13,124 ft) NOTE: The IFF Transponder or Inte rrogator Test Set and the Monopulse Antenna Simulator MUST be purchased through the SAME company to ensure product compatibility. Items shall be delivered FOB Destination to NSWCDD. This acquisition will be a Firm Fixed-Price contract. All items shall be delivered, inspected, and accepted FOB destination to NSWCDD. The solicitation number is N00178-04-Q-3043; it is issued as a request for quote (RFQ). The solicitation document and incorporated provisions and clauses are those in effect through Federal Acquisition Circular 2001-18, dated 18 June 2004, and DFARS Change Notice 20040625 dated 25 June 2004. The North American Industry Classification System (NAICS) Code is 334513 with a size standard of 500 employees. The offeror shall provide a copy of the standard commercial warranty or better that is applicable to the items contained in this solicitation. FAR 52.212-1, ?Instructions to Offerors - Commercial Items,? applies to this solicitation and is hereby incorporated by reference. The Government will award a contract resulting from this notice to the responsible contractor whose offer conforms to this notice, meets/exceeds all the specifications for each item, can meet/exceed the required delivery schedule, has a satisfactory performance history, and is registered in the Central Contractor Registration (CCR). Offerors shall include a completed copy of the provisions at FAR 52.212-3, ?Offeror Representations and Certifications - Commercial Items? and at DFAR 252.212-7000, ?Offeror Representations and Certifications ? Commercial Items? with their offer. The following FAR and DFAR clauses apply to this acquisition and are incorporated by reference: FAR 52.212-4, ?Contract Terms and Conditions - Commercial Items,? FAR 52.212-5, ?Contract Terms and Conditions Required to Implement Statutes or Executive Orders - Commercial Items,? subparagraphs (a), (b) 1, 11, 12, 13, 14, 15, 16, 18, 19 (iii), 24; DFAR 252.212-7001, ?Contract Terms and Conditions Required to Implement Statutes or Executive Orders Applicable to Defense Acquisitions of Commercial Items,? subparagraph (a) applicable with the following clauses of subparagraph (b) thereof indicated as applicable: 252.225-7012, 252.243-7002, 252.247-7023, and 252.247-7024. The following additional DFARS provisions and/or clauses apply to this acquisition: 252.204-7004, Required Central Contractor Registration. The Government will award a contract from this combined synopsis/solicitation on an all or none basis. The closing date is 19 July 2004 at 12 noon EST. Anticipated award date is 23 July 2004. Pricing should be FOB Destination to the Naval Surface Warfare C enter, Dahlgren Division, 17320 Dahlgren Road, Dahlgren, VA 22448-5100. THE GOVERNMENT SHALL NOT ISSUE A WRITTEN REQUEST FOR QUOTATION AS ALL ITEMS ARE IDENTIFIED IN THIS FEDBIZOPPS NOTICE. All responsible sources may submit their quote by e-mail in Microsoft Word format to xds13@nswc.navy.mil. E-mail should reference N00178-04-Q-3043.
- Record
- SN00619342-W 20040714/040712212517 (fbodaily.com)
- Source
-
FedBizOpps.gov Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's FBO Daily Index Page |