Loren Data's SAM Daily™

FBO DAILY ISSUE OF MARCH 10, 2002 FBO #0098
SOLICITATION NOTICE

C -- Multi-Discipline Indefinite Delivery Indefinite Quantity (IDIQ) Contract for Architect and Engineering Services

Notice Date

3/8/2002
 

Notice Type

Solicitation Notice
 

Contracting Office

Department of the Air Force, Direct Reporting Units, 11th CONS, 110 Luke Avenue Building 5681, Bolling AFB, DC, 20332-0305
 

ZIP Code

20332-0305
 

Solicitation Number

F49642-02-R-0003
 

Response Due

4/8/2002
 

Archive Date

4/23/2002
 

Point of Contact

Maria Brodie, Contract Specialist, Phone 202-767-7966, Fax 202-767-7897,
 

E-Mail Address

maria.brodie@bolling.af.mil
 

Description

The 11th Contracting Squadron is seeking interested sources for the procurement of Multi-Discipline Indefinite Delivery Indefinite Quantity (IDIQ) Architectural Engineering (A-E) Services for the study and design of base construction projects. To meet this requirement, open-end contracts will be issued for one year with four one-year options. The contracts will have a maximum monetary limit of $750,000.00 per year for all years, with a minimum of $5,000.00 for the basic year. The initial delivery orders may not exceed $299,000.00. Four firms will be chosen through the selection process. 1. Each A-E firm must be qualified to work in one or all of the specified areas of discipline: a) Roofing/Waterproofing - A-E must have on staff, or access to, a Registered Roofing Consultant and Waterproofing Engineer/Specialist with expertise and experience in inspecting, evaluating and designing various roofing and waterproofing systems. Roofing systems include low-slope built-up, single-ply, modified bitumen and EPDM systems, as well as steep asphalt shingle, slate and metal roofing systems. A-E must have broad knowledge of, and familiarity with, a variety of moisture and air infiltration problems and have the capability of analyzing and addressing such problems. A-E must also be able to design roofing and waterproofing systems for general maintenance and repair construction. b) Civil/Structural - A-E must have on staff, or access to, a State Licensed Civil and Structural Engineer with expertise and experience in, geotechnical investigations/studies, foundation designs, topographical surveys, site and utility studies/designs, traffic studies, and environmental issues/designs. The A-E shall also have the capability of performing structural analysis/determinations on existing and new facilities of varying construction. c) Mechanical - A-E must have on staff, or access to, a State Licensed Mechanical Engineer with expertise and experience in a variety of heating, ventilating and air conditioning systems used on Bolling AFB, DC. DX expansion units, Chilled Water (CW), High Temperature Hot Water (HTHW), and Geothermal are some systems currently used. A-E must have experience with CW and HTHW systems at the plant and facility level. A-E must have experience in designing and trouble shooting of Direct Digital Control (DDC) energy management systems such as Siemens Controls and Honeywell. A-E must be able to perform in-depth analysis of existing systems to evaluate energy effectiveness of the system and give recommendations to increase energy efficiency. This applies to plant and facility levels. d) Electrical - A-E must have on staff, or access to, a State Licensed Electrical Engineer with expertise and experience in, investigating, studying and analyzing high, medium and low voltage distribution systems. A-E must be able to develop and define load demands on current base distribution systems as well as for individual buildings so that construction and repair projects can be developed to support a complete and adequate electrical distribution system, meeting all present and future demands. A-E shall be able to perform coordination studies, short circuit analysis, load demand calculations and overcurrent protection studies for the electrical distribution of the entire base or for a single facility. A-E must be familiar with both the radial and loop distribution systems, load shedding, daylighting, solar, wind and alternative technologies. e) Fire Protection - A-E must have on staff, or access to, a State Licensed Fire Protection Engineer with expertise and experience in, investigating, studying, analyzing and designing various fire detection, audio/visual annunciation and suppression systems used on Bolling AFB, DC. A-E shall have extensive knowledge of applicable codes, life-safety issues, and Federal requirements. 2. All interested A-E firms must have an on-call capability in their respective disciplines for response to emergency base situations. The firm must be willing to do extensive interviews and field investigations to acquire all necessary data to design a complete project based on a fully developed scope. All firms must have AutoCad capability and be willing to prepare design documents to comply with Air Force standards and policies. Significant evaluation factors for selection will be based on the following criteria: a) Specialized experience of the firm in the types of work requested. b) Availability of experienced key personnel. c) Capacity of the firm to accomplish the work in a timely manner. d) Past experience of the firm with respect to similar level work. e) Location of the firm in the general geographical area of the work. f) Volume of work previously awarded by the Department of Defense. 3. A-E firms that meet the requirements described in this announcement are invited to submit completed Standard Forms 254 and 255, US Government Architect/Engineer Qualifications, to the Contracting Office. **NOTE: ALL PROSPECTIVE OFFERORS MUST BE REGISTERED IN THE CENTRAL CONTRACTOR REGISTRY IN ORDER TO BE CONSIDERED FOR AWARD. Registration may be obtained at the following website: http://www.ccr2000.com/. All interested responsible sources may submit Standard Forms 254 and 255 not later than close of business 08 April 2002 to be considered. Forms should be submitted to 11 CONS/LGCF, Attn: Maria A. Brodie, 110 Luke Avenue, Room 240, Bolling AFB, DC 20332-0305.
 

Place of Performance

Address: Bolling AFB, DC

Zip Code: 20332

Country: United States
 

Record

SN00038251-W 20020310/020308213326 (fbodaily.com)
 

Source

FedBizOpps.gov Link to This Notice
(may not be valid after Archive Date)

---

| FSG Index  |  This Issue's Index  |  Today's FBO Daily Index Page |